The Triflex does not start when it is switched on.
Insert the battery as follows:
Remove the sticker from the battery.
Push the battery along the guide lines until it audibly clicks into place in the PowerUnit.
If you want to separate the sections again, press both release buttons at the side of the battery to remove the battery.
Check that the battery is positioned correctly.
Charge the battery without wall mounting.
You can store the vacuum cleaner upright and charge the battery directly:
Connect the PowerUnit to the electrobrush to provide a secure base for the vacuum cleaner.
Swing the vacuum cleaner forward until the electrobrush connector audibly clicks into place.
Plug the charging plug of the supplied charging cable into the charging socket on the bottom of the battery.
Plug the charger into a power socket.
The charging process will start.
Charge the battery with wall mounting:
Slide the PowerUnit of the fully assembled vacuum cleaner, with the battery inserted, down into the wall bracket from above.
Plug the charger into the power socket.
The charging process will start.
Insert the original Miele lithium-ion battery.
Pull the charging plug out of the charging socket on the battery.
If the battery has been charged in the charging station or directly with the charger, remove the battery from the charging station or the charger and insert it into the PowerUnit.
To activate the battery, plug the charging plug into the charging socket on the bottom of the battery.
Plug the charger into a power socket.
The battery charging state is displayed on the PowerUnit.
Check the “Battery charging state” indicator on the front of the PowerUnit.
When the battery is fully charged, the top, middle, and bottom indicators light up.
If the battery is not yet fully charged, charge it in the PowerUnit until all the indicators light up.
Unplug the charging cable from the battery and from the socket.
Your Triflex is now ready for use.
Switch the Triflex off.
Wait a few minutes and then switch the Triflex back on.
