Fault F233 (freestanding appliance)

Remove and dismantle the parts of the central spout. Assemble the parts again in the correct order.

Proceed as follows:

• 

• Carefully pull the stainless steel cover forward and off.

• 

• Remove the dispensing unit by pulling it forward.

• 

• Twist off the upper section  with the holder for the milk pipework. Pull the component off.

• Then pull the Y-shaped piece  off.

• Remove the dispensing spouts .

• For reassembly:

  Ensure the dispensing spouts are placed onto the dispensing unit with the nose facing back.

  Make sure that all parts are tightly connected to one another.

• 

• Reassemble the dispensing unit as follows:

• Push the dispenser spouts  firmly back onto the dispensing unit.

• Reinstall the Y-shaped piece .

• Reinstall the upper section  with the holder for the milk pipework. Turn the component.

• Reinstall the dispensing unit onto the central spout.

• Reinstall the stainless steel cover.

Replace the cup rim sensor, proceeding as follows:

• 

• To remove:

  • Press the two latches together; see figure.

  • The cup rim sensor is released.

• To reinstall:

  • Press the cup rim sensor from below into the holder on the central spout.

Contact Miele Service to order a new cup rim sensor.