Clean out airways indicator light comes on

Clean the lint filters as follows:

• Open the door.

• 

• Pull the upper lint filter forward to remove it.

• 

• Remove the lint (see arrows).

• 

• Remove the lint from the filter surface of all the lint filters and the perforated laundry deflector.

• 

• Turn the yellow knob on the lower lint filter in the direction of the arrow (until you hear it click).

• 

• Hold the knob and pull the lint filter forward to remove it.

• 

• Use a vacuum cleaner with a long crevice nozzle attached to remove any visible lint from the upper air flow openings.

Clean all lint filters with water:

• Wipe the smooth plastic surfaces of the lint filters with a damp cloth to clean them.

• Rinse the filter surfaces under warm running water.

• Shake the lint filters thoroughly and then dry them carefully.

• Wet lint filters could cause operational faults while drying.

• Push the lower lint filter in completely and lock it with the yellow knob.

• Push the upper lint filter in completely.

• Close the door.

Check and clean the heat exchanger as follows:

• 

• Press the round, indented area on the heat exchanger access panel to open it.

  The access panel will spring open.

• 

• Pull the toe-kick filter out by the handle.

  The right-hand guide pin comes out when the toe-kick filter is removed. The guide pin prevents the access panel from closing without the toe-kick filter.

• 

• Risk of injury from sharp cooling fins.

  You could cut yourself.

  Do not touch the cooling fins with your hands.

• Damage due to incorrect cleaning of the heat exchanger.

  The tumble dryer will not dry if the cooling fins are damaged or bent.

  Clean using a vacuum cleaner with a dust brush attached. Only pass the vacuum cleaner dust brush over the heat exchanger fins lightly, without applying any pressure.

• Use a vacuum cleaner to remove lint and residues from the heat exchanger.

• 

• Push the toe-kick filter in completely.

  This will push in the right-hand guide pin at the same time.

• Close the heat exchanger access panel.