The audible signal has been switched off or the volume setting is too low.
To change the volume of the audible signals, proceed as follows (depending on the control elements):
Turn the operating mode selector to 0.
Press the < sensor control until P1 appears on the display.
Select the OK sensor control.
The setting P1 is called up and the current status S appears.
Use the < > sensor controls to select the required volume:
Status S1 (very quiet) up to S30 (very loud)
Select the OK sensor control.
You have changed the volume of the audible signals. The P setting is displayed again.
Wait approx. 15 seconds until the time of day appears.
Turn the operating mode selector to 0 or to the Lighting position.
Select the Settings sensor control.
Use the selector dial < > to select the P4 setting.
The setting is called up and the current status S appears.
Use the selector dial < > to select the required volume:
Status S1 (melodies, volume 1–7) or status S2 (solo tone, volume 1–14).
Select the OK sensor control.
You have changed the volume of the audible signals. The P setting is displayed again.
Select the Settings sensor control to exit the menu.
Select the More sensor control.
Select the Settings menu option.
Select the OK sensor control.
Select the Volume menu option.
Select the OK sensor control.
Select the Audible signals menu option.
Select the required menu option (Melodies or Solo tone). A check will appear beside the current setting.
Select the OK sensor control.
Use the segment bar to set the volume of the required audible signals.
Select the OK sensor control.
You have changed the volume of the audible signals.
On a touch display, proceed as follows:
Select the Settings menu option from the main menu.
Select the Volume menu option.
Select the Audible signals menu option.
Select the required menu option depending on the model (Melodies or Solo tone).
Use the segment bar to set the required volume.
Confirm with OK.
You have changed the volume of the audible signals.
